Hurry up!
Sale end in:
--
天數--
小時--
分鐘--
秒
Tini 立槳板動力轉換套件
將任何週末划槳板轉變為精準的電動船艇——無需工具，無雜亂。SUBLUE Paddleboard Power Conversion Kit可在不到一分鐘內將Tini動力模組鎖定於99%的充氣SUP上，透過無線遙控器輕觸即可實現靜音且油門平順的推進。
即插即用安裝 — 滑入、鎖緊、划槳；1.14公斤攜帶架無需鑽孔或環氧樹脂即可固定。
單引擎或雙引擎靈活選擇 — 單台Tini巡航速度3.2–4.5公里/小時，雙引擎則可衝刺至7公里/小時。
45分鐘續航 — 快速更換鋰電池讓你持續探索；備用電池可將續航加倍。
智慧水控 — IP等級遙控器切換兩速；按下啟動，放開停止——無線纜，僅藍牙連接。
為惡劣環境打造 — 航海級材料、磁吸充電及60點防腐蝕測試，確保季節復季的可靠性。
包裝內容
• 攜帶架 & 防丟掛繩
• 中繼模組 & 控制器
• 快拆螺絲、磁吸充電器、墊片、貼紙
(可選單引擎或雙引擎套裝：單引擎套裝包含一台Tini滑板車；雙引擎套裝則額外包含第二台滑板車、支撐手柄和連接器。)
提升你的SUP——滑行更遠，衝浪更強，掌控每一個地平線！
Pairs well with
Tini 立槳板動力轉換套件
Paddleboard Power Conversion Kit
Tool-free quick installation.Turn your SUP into an electric board
The mounting frame secures the kit firmly to the tail of the board.The sliding rail lets the Tini power unit slide in and out for fast swap.
Lightweight design, easy to carry.
Premium materials with a skeletonized bracket.The mount stays rigid while keeping the weight down.
Wide compatibility with most inflatable SUPs.
Designed for inflatable boards—enjoy smooth rides on the water.
Wireless control with one-click start/stop
A wireless controller operates the Tini system with stable, easy control.Press to start, release to stop—intuitive and handy.Two speed levels switch with one button for flexible pacing.
※The controller can be mounted on the paddle shaft.
Powerful drive with up to 75 minutes of runtime
The Tini system uses a rechargeable lithium battery.
98Wh pack: typical use about 45 min.
158Wh pack: typical use up to 75 min.
Carry spare batteries to swap quickly for longer sessions.
Rechargeable lithium battery
Smooth power for effortless gliding
Single-propulsion system with two speed modes.
Cruising speed up to 4.5 km/h.
To build this setup you need:
Paddleboard power kit ×1
Sublue Tini power unit ×1
Twin-motor thrust for high-speed cutting across the water
Dual-propulsion system with two speed modes.
Cruising speed up to 7.0 km/h with doubled power.
To build this setup:
Paddleboard power kit ×1
Sublue Tini power units ×2
Dual-mount bracket ×1
Dual-mount connector ×1
| Paddleboard Power Conversion Kit | Table header 1 |
|---|---|
| Mounting frame | 224×225×296 mm (L×W×H) |
| Adapter module | 154×171×250 mm (L×W×H) |
| Controller | 41×70×80 mm (L×W×H) |
| Weight | Frame 1140 g; adapter 650 g; controller 85 g. |
| Speed by gear | Single-motor: Low 3.2 km/h, High 4.5 km/h. Dual-motor: Low 5.4 km/h, High 7.0 km/h. |
| Endurance | Controller: 300 min; adapter module: 240 min. Power unit typical use 45 min (98Wh battery). Typical use 75 min (158Wh battery). |
| Charging time | Controller 180 min; adapter 120 min. Power unit: 120 min (98Wh pack); 210 min (158Wh pack, or 120 min with fast charge). |
| Board compatibility | Material/type: Inflatable SUP, PVC. |
Tail size/shape requirements: see diagram below (dimensions in mm).
※“Typical use time” is measured with fully charged devices under general usage (non-continuous) and reflects the average of maximum achievable time.
※This kit does not include the Sublue Tini power unit, dual-mount bracket, dual-mount connector, or the inflatable SUP.
